- 400amp
- Size: 5meters
- Volts: 12-24V Heavy duty
- Booster cable
- Emergency cable
- Power plus
- Fully insulated grips and cable
- Quality rubber adoption
- High conduction solder
- Support of grip cord
- Safe steps to booster starting:
- Step 1: Before you attempt to jump start the car, make sure both batteries are of similar voltage or you risk damaging electrical components.
- Step 2: Get the cars as close together as possible but do not allow the cars to touch one another.
- Step 3: Win both cars off and in park, connect the jumper cables in the following order.
- (1) Connect one red clamp to the positive () battery post of the dead battery.
- (2) Connect the other red clamp to the posave () past of the good battery.
- (3) Connect one blace-end clamp to the negative () post of the good battery.
- (4) Carefully connect the other back-end clamp to some large metalic part of your cars engine block.
- Never connect it to the negative (-) post of the dead battery because this causes sparking which could ignite battery gases.
- Step 4: Next start the working car and run it at idling speed for a few minutes.
- After letting it run start the dead car.
- Once your dead car has started and is running,
- immediately disconnect the jumper cables in the reverse order and make sure to let it run idle for at least 30 minutes or drive it around for a little while to recharge the battery.
- Kindly note that actual product color may vary from the images shown.
- Lighting conditions at the time the photo was taken can also affect an image's color.
- For more questions about this product, please don't hesitate to message us.
- Thank you and happy shopping!
